English
Deutsch
日本語
Français
Español
Tiếng Việt
usheenthermal
alibaba
In the ordinary life and work, the Thermal Silicone Adhesive film has been gradually widely used in electronic and electrical products control board, motor, external pad and foot pad, electronic appliances, automotive machinery, computer host, laptop, DVD, VCD and any Need to fill and heat the module material. It is made of silicone as material, adding metal oxide and other auxiliary materials, processed into a thermal medium material, the main function is dedicated to the use of gap heat transfer, but also play insulation, shock absorption, sealing and so on.
The following author to share the use of Thermal Silicone Adhesive film.
1. Keep the surface of the silicone film with the end of the clean, to prevent the thermal conductivity of Thermal Silicone Adhesivefilm sticky filth, filthy thermal conductivity of silicone film self-adhesive and sealing thermal conductivity will be worse.
2. Take the Thermal Silicone Adhesive film, the area of large Thermal Silicone Adhesive film should be crawled from the central site, the smaller the size of the sheet is not required to grasp, because the large pieces of thermal conductivity of silicone film uneven, will lead to deformation, Follow-up operation, and even damage the silicone film.
3. Take the left hand sheet, the right hand to tear off one of the off-type protective film. Can not tear both sides of the protective film at the same time, to reduce the number of direct contact with the thermal conductivity of silicone film and area, to maintain thermal conductivity of silicone film self-adhesive and thermal conductivity will not be damaged.
4. Tear off the side of the protective film, toward the radiator, the first thermal conductivity of the silicone film aligned radiator. Slowly put down the Thermal Silicone Adhesive film. Be careful to avoid the generation of bubbles.
5. If the operation of the bubble, you can pull up the end of the above steps to repeat the above steps, or gently wipe the bubble with the tools, but the power is too large, so as not to damage the Thermal Silicone Adhesive film.
6. Remove the other side of the protective film, into the radiator, tear off the last side of the protective film to small, to avoid injury or pull up the Thermal Silicone Adhesive film.
7. Fastening or strong thermal conductivity of silicone film, the radiator to exert a certain pressure, and stored for some time to ensure that the Thermal Silicone Adhesive film fixed.
In summary, the thermal effect of thermal conductivity of silicone film is very good, and in the installation of Thermal Silicone Adhesive film, it is recommended that you should be careful not to be too impatient, resulting in air bubbles and thermal film received damage Wasted money and wasted time.
SC900FG(Soft Tack) is a fiberglassreinforced thermal interface material featuring inherent tack on both sides. The material exhibits excellent thermal performance at low mounting pressures. The material is supplied on two liners for exceptionally easy handling prior to auto-placement in high volume assemblies. The material is ideal for placement between an electronic power device and its heat sink.
+86 13728278261
+86 13728278261
